Current Cost Support Forum http://www.currentcost.com/support/ |
|
Optismart Readers Two Meters with Different Flash/kWh Rates http://www.currentcost.com/support/viewtopic.php?f=18&t=21981 |
Page 1 of 1 |
Author: | philipbradbury [ Tue Feb 28, 2012 7:18 pm ] |
Post subject: | Optismart Readers Two Meters with Different Flash/kWh Rates |
Is it possible to monitor two different electricity meters (the import and generation meters on a solar PV installation) using two Optismart devices into a single Envir receiver. The import meter flashes at 1000 impulses/kWh, the generation meter flashes at 1600 impulses/kWh. Both meters show no flashing, or a solid red LED, when zero or reverse current is detected so the readings should show the import energy and the solar PV energy accurately. I have read the instructions but cannot see where you would enter the two different, 1000 and 1600, calibration figures. |
Author: | frumper [ Fri May 18, 2012 2:38 pm ] |
Post subject: | Re: Optismart Readers Two Meters with Different Flash/kWh Ra |
yes, i'm doing exactly this: http://pvoutput.org/intraday.jsp?id=7304&sid=6653 consumption @1600imp/kWh on 9 & 1, generation @ 1000imp/kWh on 8 & 2, outputing via a bridge. |
Author: | Automan [ Fri May 25, 2012 9:43 am ] |
Post subject: | Re: Optismart Readers Two Meters with Different Flash/kWh Ra |
When you assign the OptiSmart data channels you set the meter pulse rate. Say channel 9 you would set to 1000 (the default) and when you set the other one up use channel 8 for data and set that to 1600. The channels you set/select for the real time readings should then read correctly. Automan. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |