Current Cost Support Forum http://www.currentcost.com/support/ |
|
Pairing More Than One OptiSmart With An EnviR http://www.currentcost.com/support/viewtopic.php?f=18&t=1075 |
Page 1 of 1 |
Author: | Automan [ Thu Aug 25, 2011 10:30 am ] |
Post subject: | Pairing More Than One OptiSmart With An EnviR |
Got one up and running with no problems But as the gadget comes with no instructions so hints on how to pair a second one would be useful. See http://currentcost.com/download/Current ... ingles.pdf on how to pair one. Do you use channel 9 again or perhaps 8? Then do you pair it again (after the three flashes) with a spare appliance channel? Automan. |
Author: | Automan [ Thu Aug 25, 2011 11:10 am ] |
Post subject: | Re: Pairing More Than One OptiSmart With An EnviR |
Just tried setting the data on 8 and display on chn1 which worked first time. Only load on this meter is 52 watts which matches closely the data from an IAM on the same load which reports 50 watts. EDIT: Output now being sent to http://pvoutput.org/list.jsp?userid=4392 Automan. |
Author: | skmorgan1944 [ Tue Sep 06, 2011 1:35 pm ] |
Post subject: | Re: Pairing More Than One OptiSmart With An EnviR |
Author: | series530 [ Mon Jan 16, 2012 9:31 am ] |
Post subject: | Re: Pairing More Than One OptiSmart With An EnviR |
I have 2 optismarts and two EnviR's. I just bought a bridge and have one of them connected to the CC dashboard. I would like to 1 EnviR and one optismart just showing incoming consumption (on the consumer meter) and the second EnviR showing data from the first optismart together with the second optismart (connected to the PV meter). At the moment, I cannot get the first optismart to pair with both enviR devices and display the same data on both. Is it possible? If so, what is the trick? thanks Ian |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |