NetSmart - Specifications
Operating voltage: |
5v |
Input Voltage (limits) |
6-20V |
Power Adapter: |
9VDC, 300mA, 2.1mm center positive. Power can also be provided using the USB port. |
Weight: |
142g |
Dimensions: |
68mm x 68mm x 26mm |
Communication: |
Serial communication over USB with debug output. USB can also be used for powering the prototype bridge. |
Automatic Software Reset
|
The NetSmart can be reset by unplugging the power from the NetSmart, wait 5 seconds, then re-connect the power to theNetSmart. This will do a clean reset of the NetSmart, which will then cycle through setting up DHCP and communicating with the Current Cost broker. |
Microcontroller: |
ATmega328P |
Memory: |
16 KB of flash memory |
EEPROM: |
512 bytes |
RJ45 Ethernet port: |
The RJ45 Ethernet port has two LEDs: Link/Act and 10/100. The Link/Act LED should be on when connected. If the Link/Act LED is not ON, this usually means there is a bad network connection or bad cable. More details about LED activity: |
LED: Link Activity (LINK/ACT) GREEN = link active BLINK = network activity OFF = link inactive LED: 10/100 Baud Rate / Network Speed AMBER = 100Mb OFF = 10Mb |