The Bridge where to buy

The Bridge - Specifications

Operating voltage:
5v
Input Voltage (limits)
6-20V
Power Adapter:
9VDC, 300mA, 2.1mm center positive. Power can also be provided using the USB port.
Weight:
142g
Dimensions:
100mm x 76mm x 41mm
Communication:
Serial communication over USB with debug output. USB can also be used for powering the prototype bridge.
Automatic Software Reset
The bridge can be reset by unplugging the power from the bridge, wait 5 seconds, then re-connect the power to the bridge. This will do a clean reset of the bridge, which will then cycle through setting up DHCP and communicating with the Current Cost broker.
Microcontroller:
ATmega168
Memory:
16 KB of flash memory
EEPROM:
512 bytes (ATmega168)
RJ45 Ethernet port:
The RJ45 Ethernet port has two LEDs: Link/Act and 10/100.
The Link/Act LED should be on when connected. If the Link/Act LED is not ON, this usually means there is a bad network connection or bad cable. More details about LED activity:
  LED: Link Activity (LINK/ACT)
GREEN = link active BLINK = network activity OFF = link inactive
LED: 10/100
Baud Rate / Network Speed AMBER = 100Mb OFF = 10Mb

 

software downloads partners